Sound Technology

Wrapped up this absolutely legendary Ampeg Bass Amp Friday. This got the full works with new Electrolytic Caps, a full re-tube with Tung-Sol Reissues and an upgrade to 5881 Output Tubes. The original power cord was replaced, lamps were upgraded and full alignment and bias. Tyler did a fantastic job on the unit. After the upgrades there is much more power and headroom. It still maintains its vintage tone which was critical. The photos and video speak for themselves!

Incorporated in the state of Florida 1975 

This monster McIntosh Amp hasn't been touched since new. The original lamps were all out and the gels for the VU meter had discolored. An LED lamp upgrade and new gels has it looking brand new once again.

Appreciate everyone's patience as the shop deals with a rough Flu outbreak. Whatever has been going around has hit the shop hard over the last couple of weeks. I'm in the shop answering phones but repairs have ground to a halt as all but 1 part time tech are out with illness. We thought we were past it this week but I had send 2 of the techs home as they clearly aren't ready to be in just yet.

Thank you all for your continued support. We will be back hard on the bench, hopefully sooner rather than later.

Send a message to learn more

Sometimes its good to give us things to look over, even if it's working well. Case in point with this Sansui 5000A where the glue used to attach the thermal feedback devices to the heat-sink has become conductive and corrosive. While the unit was still currently functioning, it could have been catastrophic if not addressed immediately. Lucky for this gentleman. We will clean up what we can and replace what we can't!