PJBuilt Automotive

Completed this F22C build at the end of last week for a good customer of mine. He purchased a Honda S2000 that was neglected by the previous owner with plans to bring it back to life. So he brought me the engine for a refresh and it was worse than we thought once I took a look at it. The engine was locked up and needed a complete rebuild. He wanted me to build him a reliable engine with a few extras while I’m in there and I was glad to make that happen. After all the new parts and hours of cleaning and assembly this engine has been brought back up to spec plus some. Now the engine is in the car and is running great. Needless to say the customer was excited to see the car alive again! Only thing it needs now is a little break in time and then it’s ready to eat! 😎💪🏾

Finished off the week with this pretty cool project..had one of my good customers come in wanting more steering angle on his 2005 350z he uses for drifting..needless to say he was a happy customer after it was all said and done 😁💪🏾..now off to the alignment man so he can get everything back in spec and enjoy his car 😎

Block is assembled and done ✅
-ACL race bearings full set
-RRC Nippon Racing pistons
-Stock rods
-Type s oil pump ported and shimmed by vhb engines
-Stock block/sleeve
Next up is the cylinder head, stay tuned 😎

A customer came in with problems with the car being sluggish and not having power. We diagnosed the issue and discovered that the timing was off (2nd pic). We adjusted his timing and TPS and now this Civic is running strong 💪🏻

Our customer had an issue with her Audi A7 losing coolant as soon as she would add it. After a thorough diagnosis we found the leak - a hole in the cylinder head coolant pipe. After placing the A7 into service mode, we were able to successfully replace the pipe and get this Audi back on the road.