Taha Caner - Prop/Design

Hunter! act before you think but if you see Extremoth just run. RUUN

Swipe Left for next photo!

(I was able to take 50 poses from 270 photos, 50! )

@ Rumeli Feneri, Garipce

Darksider - Strife

Ahhh I want to wear my strife again... Soon i will update some of parts and take a good photo shoots with my bro death.

Photo and editing :

Lets give tips!

There are many ways to achieve a smooth surface. If I'm making a special piece or something for me, I usually use polyester paste/putty. Its ideal for making a product into a finished product. creates too much dust, consumes too much sandpaper but the result is very good.

TR
3D print sonrasi layerlari temizlemek icin bir ck yol var. Ben kendim icin bir sey yapiyorsam genellikle polyester macunu kullaniyorum. Cok fazla toz cikariyor biraz fazla ugrasmak gerekiyor ama sonuc mükemmel bir bitmis ürün oluyor.

announces

So here Closeup detail of Strife Cosplay.
All armor part made of EVA foam and hand made supported with leather.
Body suit made of latex and guns made of half 3D Print half PVC board.
I will update my costume because of lack of reference photo when i did this. And i will wear costume of this summer! So wait new photos!!!