Harris Performance Engineering NZ Ltd
Share
Machining thicker thrust bearings out of solid phosphor bronze bar s in a rotary table. Manual machining on one of my turret mills. Parted off the blanks in the lathe very carefully and hand finished to correct clearance. Toyota 5K engine now racing hapilly again in New Zealand.
15/07/2020
We've been super busy getting engines back together along with machining parts for proper fitment. We are looking forward to seeing what these two engines can do. The RB30/26 has had some breathing and oil control mods along with full balancing and bearing clearances being set correctly. The 1UZFE has had a full rebuild with new rings, bearings, balancing, porting and polishing and compression increase. That one is going into a marine application and will be set up with a Link ECU.
Click here to claim your Sponsored Listing.
Category
Contact the business
Telephone
Address
114 Vincent Street
Howick
2014
Opening Hours
| Monday | 8am - 5pm |
| Tuesday | 8am - 5pm |
| Wednesday | 8am - 5pm |
| Thursday | 8am - 5pm |
| Friday | 8am - 5pm |
