Ask Volt

How to get low-level library permits in TLE9893?

How to get low-level library permits in TLE9893? HiWe are using the TLE9893 and I would like to know if there is a low-level library that permits getting to the registers of the IO peripherals. Not full drivers but instead just schedules that allow to write to each ...

Stwlc38 VOUT pin input voltage subordinate op mode exchanging issue

Stwlc38 VOUT Pin Input Voltage Subordinate op Mode Exchanging Issue? Hi I am as of now working on a venture using stwlc38. I am using it in conjunction with a control administration IC, MAX17330. The circuit is simple, VOUT and system power is associated and ordinarily I use it to release the ...

How RA4M1 UART control the RE/DE signal for a RS485

How RA4M1 UART control the RE/DE signal for a RS485 Can the RA4M1 UART control the RE/DE signal for a RS485 line driver in equipment, or does FSP control it in software?

RA TrustZone configuration error

RA TrustZone configuration error Hello Everybody,I am working on EK-RA4M2 board and a few how from recently i am incapable to streak anything on my target board since of Trustzone

How to Use ESD114U102ELE6327XTMA1 ultra-low capacitance TVS diode in PCB's?

How to Use ESD114U102ELE6327XTMA1 ultra-low capacitance TVS diode in PCB's? Hello,We use the ESD114U102ELE6327XTMA1 ultra-low capacitance TVS diode on numerous of our PCB's. The item status for this diode is "not for modern design". Is Infineon developing a drop-in replacement? If not, can you ...

How to reset factory chip STWLC38 without I2C link?

How to reset factory chip STWLC38 without I2C link? Hello,I have a custom board with a STWLC38JRM.Everything was fine and I was able to flash it with STSW-WPSTUDIO v1.8.4 through the dev board STEVAL-WLC38RX and FT_SDA/FT_SCL/VBUS/AGND pins.