Innixsoft

Know about some Electrical / Electronics Components .......

SHADOW OPERATED MOTION DETECTOR

check this out

soyrce-discovercircuits

OVER TEMPERATURE ALARM

The circuit is powered for years by a single 3 volt lithium battery. It sounds an alarm when the temperature exceeds a certain point. With some minor changes the circuit could also be configured for an under temperature (freeze) alarm. The circuit uses a cheap but accurate thermistor as the temperature sensor.


source-discovercircuits

Have you Wondered how an EMF is induced across its terminals when prone to vibration..........??


READ THIS FOR SOLUTION


When electrical stress is applied to one axis of a quartz crystal it exhibits the piezo-electric effect: a mechanical deflection occurs perpendicular to the electric field. Equally, a crystal will produce an e.m.f. across the electrical axis if mechanical stress is applied to the mechanical axis.

If the stress is alternating – the movement of the diaphragm of a crystal microphone is an example – the e.m.f. produced will be alternating at the frequency of the movement. If the stress alternates at a frequency close to the mechanical resonance of the crystal as determined by its dimensions, then large amplitude vibrations result.

Polycrystalline ceramics possess similar qualities. Quartz crystals used for radio applications are slices cut from a large, artificially grown crystal.

The slices are then ground to the appropriate size to vibrate at a desired frequency. The performance of an individual slice – the crystal as the end user knows it – depends upon the angle at which it was cut from the parent crystal.

Each crystal slice will resonate at several frequencies and if the frequency of the stimulus coincides with one of them the output, electrical or mechanical, will be very large.

The vibrations occur in both the longitudinal and shear modes, and at fundamental and harmonic frequencies determined by the crystal dimensions.

There are three opticalaxes (X, Y and Z) in the crystal used to establish the geometry and locations of various cuts. The actual crystal segments used in RF circuits are sliced out of the main crystal. Some slices are taken along the optical axes, so are called Y-cut, X-cut and Z-cut slabs. Others are taken from various sections, and are given letter designations such as BT, BC, FT, AT and so forth.


source-atombuz