AP9engineering

I've been designing this brake setup for quite some time now. And things change along the way. A good example here is the brake caliper bracket which I was happy with until I realised that there is not much room in this area to accommodate the disc cooling duct and the best place for it is next to the caliper cooling duct. So eventually a new bracket needed to be designed that in a way integrates the disc cooling ducts which guide air directly to the center of the rotor.
While I wait for this new bracket to be machined I can work on the ducts and create stiff and lightweight carbon versions of those. On the table are MJF printed PA12 Nylon versions which is my go to plastic printing solution due to it's good surface finish and more accurate features.

After this the front brakes should largely be finished. Next I'll dive into creating new brake lines throughout the car while also creating some brackets and routings for the air hoses themselves.

I'm planning to restock the Saab C900 spring bushings. For best price and availability I'm opening up a preorder so that everyone can get a complete set of 8 or any other number of specific bushings.

Let me know of your interest by sending me an email to [email protected]