airbornfpv

Full based Glide Hammer (reversed and swapped central plate and bottom plate) now ready to fly on new sexy motors! Last one failed!
we’re smooth and had a punch! But one of them got bent shaft!! Shaft! I don’t remember when I bent one last time 😂 over the dirt and grass crashes 🤣 no no in my book! No we test motors 🤗🤗 lower KV but we shell see

No filters, it looks vibrant as hell 😳😍😍😍

In process of hydro dipping Orqa case for an awesome custom look 😵🥰✅✅ subscribe 😜

Orqa
DL Hydrographics - Wassertransferdruck im Saarland und der Welt

Best bag ever 🥰 thanks 🙏
- (hidden gem people!!! Get it! Build it with esc between arms and lower deck)
- glide tank (central plate and bottom plate switch around! Esc between arms! I also cut away the front section and saved 10g, camera is at the tail - new front 😜)

Both rock on 51433 props but one on EmuFlight + Zeez and one is on full

smoox 2306 plus 2580kv are Awesome 😍 But they deserve another post as I have few stories to share with them lol 😆

- 2020 stack is the best FC for EmuFlight you can get in my opinion 😳 And did an insane job filtering - it flies almost JUST LIKE ! It is smooth as butter, prop wash is just a touch more than on full Fettec! I can not advice enough, all betaflight pilots MUST try one 5inch on EmuFlight!!! It is so much better!
•
Lastly, after long tests 51433 is 100% best over all prop out there - best in what matters (great thrust, no less than other even higher pitch props! Great efficiency, if not the best! And yet one of the highest RPM at any given throttle position - easier to control for the motor = less prop wash, more locked in!)

———-
you guys need to finally add BlackBox support 👌😊

2020 esc is way to long (Fettec 30x30 45amp esc ends up being more compact than your 20x20 due to sticking out battery lead pads ...)

thank you, I will publish motor prop test data very soon 👍👍👍

Have done some testing and analysis of 3inch motor / prop. vs Gemfanhobby prop
of vs motors.

I was not planning to post it right now, but up on special request - there it is.

My conclusions:
- HQ prop is extremely inefficient & produce even less thrust than GF props on both motors. (bad prop design)
- GF3016 prop is SIGNIFICANTLY more efficient, and the fact that it produces more thrust (due to higher RPM archived) is amazing. On both motors

- Fettec motors provide 25% more thrust at 30% throttle (10g) and 25% more thrust at 50% throttle (20g)! This is every substantial increase considering that would equal to 80g from 4 motors on a 100g quad :D
- FPVcycle Motors though do provide 15-20% better efficiency (it is very efficient indeed, specially with GF3016)

= at the end of the day, don't use HQ3x2.5x3 on those motors, load is too high for that size motor or design is flowed.
= And as for motors - FPVcycle have higher max thrust even tough they will get to it later in the stick movement - which will directly translate into throttle resolution!

Please note 2 Fettec motors burned down at 1850 pwm (started to smell at 1750pwm already), while FPVcycle seem to have better over load ability (see amps!) and managed to pass all 2000pwm with some slight smell at max.

5 inch testing is coming along :) Stay tuned for you tube over view

Artem - AirbornFPV