Equal Access Construction

2010 ADA Standard 405.5 Clear Width. The clear width of a ramp run and, where handrails are provided, the clear width between handrails shall be 36 inches (915 mm) minimum. EXCEPTION: Within employee work areas, the required clear width of ramps that are a part of common use circulation paths shall be permitted to be decreased by work area equipment provided that the decrease is essential to the function of the work being performed.

Contact us today for a confidential and complimentary ADA advisory- https://yourequalaccess.com/ada-consultation/

[Image with a title of 405.5 Ramp Clear Width. Combines a picture of the width of a ramp being measured with a measuring tape alongside an illustration showing the ADA standard for ramp width. At the bottom there is the Equal Access Construction logo and the slogan 'Every one, every door, every time.]

Installing grab bars in toilet stalls is essential for ensuring compliance with the Americans with Disabilities Act (ADA) and increasing the accessibility of restroom facilities for individuals with mobility impairments. These grab bars provide crucial support and stability for individuals with disabilities who may have difficulty sitting down or standing up independently. By incorporating grab bars into toilet stall design, restroom facilities become more inclusive and accommodating, allowing all individuals to use the facilities comfortably and with dignity. This simple addition enhances accessibility and promotes equal access to essential amenities for everyone, regardless of their mobility needs.

Receive a complimentary confidential consulation with our ADA experts- https://yourequalaccess.com/ada-consultation/

[Graphic with title 'Let's Remove Barriers' and a photograph set in a circle of an accessible restroom toilet with grab bars on the rear and sidewalls. A subtitle of 'Install Grab Bars in Restroom Stalls. At the bottom, the Equal Access Construction logo and slogan 'Every one, every door, every time.]

505.7.1 Circular Cross Section. Handrail gripping surfaces with a circular cross section shall have an outside diameter of 1¼ inches (32 mm) minimum and 2 inches (51 mm) maximum.

[Image with title in top right of ADA 101 and subtitle of the ADA standard 505.7.1 Handrail Circular Cross Section. Picture of a circular handrail being measured for its diameter and diagram showing the corresponding ADA measurement. At bottom Equal Access logo and words Every one, every door, every time.]