Surron Workshop Rotherham

Haven’t posted for a while as it’s been busy!

Talaria sting in for a new tyre and heavy duty tube 🛞

Magura front brake pads and bleed 🔧
Tektro rear pads and bleed 🔧
Suspension issues diagnosed and rectified 🔧

Another two boxed off today

Jackshaft rebuilt, removing the terrible OEM bearings and replacing with SKF high temp bearings and seals, all threads chased and cleaned,ready to re fit as part of a bigger project 🔧✅

Display sourced and fitted for a returning customer, routed as it should and tested 🔧✅

A very clean LBX in for a new breaker this evening 🔧🔋

Surron through the workshop after crash damage

Diagnose and route new OEM throttle
Diagnose and remove faulty tilt sensor
Wiring repair to ignition
New grips
Brake bleed front and rear
Rear disc and pads
Chain tensioned correctly and lubricated
Eco/sport button fitted
Anodised peg brackets
Brake hose routed

Running quiet as a mouse 🐭
A few quotes sent to customers tonight

WhatsApp below for enquiries 🔋🔧

Surron LBX on the ramp today for

🔧 Brake caliper/ Pads/ Brake bleed
🔧 New rear innertube
🔧 rear under seat mudguard

No pictures this time as was too busy 🤣

WhatsApp the below to book in 🔧

Another LBX in today for diagnosis after a crash

Tilt sensor removed due to internal failure
Eco/sport button repaired
Ignition wiring repaired
No throttle issue diagnosed, open circuit in throttle cable
Damaged foot peg mounts removed

Parts sourced and on order for a quick turn around so the customers back on his bike 🔋🔧

Talaria sting through the workshop these last few days for

Brake pads front & rear
Brake bleed
Mudguards front and rear
Rear tyre and tube
Chain adjusted & lubricated
Chain guard fitted
Rear brake master cylinder and lever

WhatsApp below for any bookings/parts sourcing 🔧🔋

Surron through the workshop for rear brake hose leak, new barb/olive/boot fitted and a brake bleed.

Customer asked if we could diagnose his Speedo issue at the same time, traced back to a break in the loom.🔧🔋

Surron LBX through the workshop for a new Gates Powergrip belt, horn wiring repaired & a brake bleed

Health check carried out whilst on the ramp, motor spacers missing and a few loose bolts, parts sourced and customer booked back in for the work carrying out.

For any enquires message the WhatsApp at the bottom of the post 🔋🔧